How to make plunger coffee

How to Make Plunger Coffee at Home

To make plunger coffee, use about 1g of coarsely ground coffee for every 16ml of water, so roughly 31g for a 500ml plunger. Pour in water just off the boil, stir, put the lid on and steep for four minutes. Then press the plunger down slowly and pour straight away.

That is the whole method. The rest of this guide covers the details that turn an average cup into a great one: how much coffee to use for your plunger size, the right grind, why water temperature works differently on the Highveld, and how to fix coffee that tastes bitter, weak or muddy.

What is plunger coffee?

Plunger coffee is what South Africans call coffee made in a French press: a glass or steel jug with a mesh filter on a rod. The method is called immersion brewing, because the ground coffee sits fully submerged in hot water rather than having water drip through it as in a filter machine. When it is ready, you press the mesh down to trap the grounds at the bottom.

Immersion gives plunger coffee more body and a richer, rounder texture than filter coffee, because the metal mesh lets through the coffee’s natural oils that a paper filter would hold back. It needs no electricity and no paper filters, and it is hard to get badly wrong.

How much coffee do you need for a plunger?

A good starting point is a 1:16 ratio: 1g of coffee for every 16ml of water. If you like it stronger, move towards 1:15. For something lighter, try 1:17.

 

Plunger size Water Coffee at 1:16 Roughly in level tablespoons Serves
3-cup 350ml 22g 4 1 large mug
4-cup 500ml 31g 5 to 6 2 cups
6-cup 800ml 50g 9 3 cups
8-cup 1 litre 63g 11 to 12 4 mugs

 

The tablespoon figures are approximate. A level tablespoon of ground coffee weighs roughly 5 to 6g, depending on the grind. A kitchen scale is the easiest way to get consistent results, and it takes the guesswork out of every brew.

Plungers rarely brew well at their full marked capacity, so leave about 2cm of space below the rim for the lid and the crust of grounds.

What grind should you use for plunger coffee?

Use a coarse grind, about the texture of coarse sea salt. A coarse grind gives you a clean, full-bodied cup and lets the plunger press down smoothly.

  • Too fine, and the coffee over-extracts and tastes bitter. Fine particles also slip through the mesh and leave sludge in your cup, and the plunger becomes hard to push.
  • Too coarse, and the water cannot draw out enough flavour, so the coffee tastes thin and sour.

If you grind your own beans, grind just before brewing and set your grinder to its coarse range.

If you buy pre-ground coffee, look for a grind made for plungers. Mugg & Bean ground coffee is medium-coarse ground and suitable for French press (plunger) brewing, as well as filter machines and moka pots. Because a medium-coarse grind extracts a little faster than a coarse one, start with a slightly shorter steep of about three and a half minutes, and press gently.

Not sure whether to buy beans or ground? Our guide to coffee beans vs ground coffee compares the two.

How hot should the water be?

The usual advice is water at about 93 to 96°C, which means letting a just-boiled kettle stand for around 30 seconds. Water at a full rolling boil can scorch the coffee and bring out bitterness, while water that is too cool leaves it weak and sour.

On the Highveld, the rule changes. Water boils at a lower temperature at altitude. In Johannesburg, at about 1,750m above sea level, it boils at roughly 94°C, and in Pretoria at roughly 95°C. That is already in the ideal range, so in Gauteng you can pour straight from the kettle as soon as it clicks off. At the coast, in Durban, Cape Town or Gqeberha, give the kettle 30 seconds to settle first.

How to make plunger coffee: step by step

You will need a plunger, coffee, a kettle, a spoon and a timer. A kitchen scale helps.

  1. Warm the plunger. Swirl a little hot water in the empty jug, then pour it out. A warm jug keeps the brew at the right temperature.
  2. Add the coffee. Weigh out your coffee using the table above and tip it into the jug.
  3. Pour in a little water and wait 30 seconds. Add just enough hot water to wet all the grounds, about twice the weight of the coffee. You will see the coffee bubble and rise as freshly roasted coffee releases carbon dioxide. This step, called the bloom, helps the water extract evenly.
  4. Add the rest of the water. Pour it in steadily until you reach your measured amount.
  5. Stir gently. Give it a few stirs so no dry clumps remain.
  6. Put the lid on and steep for four minutes. Rest the lid on top with the plunger pulled all the way up. Keep the lid on to hold in the heat. For medium-coarse pre-ground coffee, try three and a half minutes.
  7. Press slowly. Push the plunger down gently and steadily, over about 15 to 20 seconds. If it resists strongly, your grind is too fine. Do not force it.
  8. Pour straight away. Serve all the coffee immediately, or decant it into a flask or carafe. Coffee left sitting on the grounds keeps extracting and turns bitter within minutes, even after you have pressed.

How long should you leave coffee in a plunger?

Four minutes is the standard steeping time for coarsely ground coffee, and it is the best place to start. Then adjust to taste:

  • Shorter (three to three and a half minutes) for a lighter, brighter cup, or for medium-coarse pre-ground coffee.
  • Longer (up to five minutes) for a heavier, stronger cup with a coarse grind.

Change one thing at a time, either the steeping time, the ratio or the grind, so you can tell what made the difference.

Why does my plunger coffee taste bitter, weak or muddy?

Problem Likely cause Fix
Bitter or harsh Grind too fine, steeped too long, or left sitting on the grounds after pressing Grind coarser, steep for less time, and pour immediately after pressing
Weak or watery Too little coffee, or steeped too briefly Use more coffee (move towards 1:15) or steep for longer
Sour or thin Grind too coarse, or water too cool Grind a little finer; at the coast, use water closer to boiling
Muddy or gritty Grind too fine, plunger pressed too hard, or the last pour taken from the bottom Grind coarser, press gently, and leave the last few millilitres in the jug
Plunger hard to press Grind too fine Use a coarser grind, and never force the plunger
Flat or dull Coffee past its best Use coffee within six months of packing, and store it sealed

 

On freshness: our roastery finds that coffee is still fresh when used within six months of packing, and sets its shelf life at 12 months. Read more in how long does coffee stay fresh?

Can you make plunger coffee with milk?

Yes. Brew the coffee as normal and add warm milk to taste. For a café-style texture, you can froth milk in a clean plunger:

  1. Warm the milk (do not boil it) and fill a clean plunger no more than a third full.
  2. Pump the plunger up and down quickly 15 to 20 times until the milk doubles in volume.
  3. Pour it over your coffee.

Full-cream milk froths most easily. Rinse the plunger well afterwards so no milk taste carries over to your next brew.

Which coffee is best for a plunger?

Plunger brewing suits coffees with good body and a smooth, chocolatey or nutty character, because immersion brings those qualities forward. Here are good places to start from the Bean Online range, based on each coffee’s published profile.

Ready ground for your plunger (250g)

  • Mugg & Bean Café Blend: a medium roast with warm spice, chocolate and stone-fruit tones, balanced for any brew method. A reliable everyday choice.
  • Mugg & Bean Mocca Java Blend: a medium-to-dark roast of Ethiopian and Indonesian beans with hints of fruit and walnut. The darker roast keeps acidity low, so it is smooth enough to drink black.
  • Mugg & Bean House Blend: medium roasted, with a smooth, aromatic hint of almonds and enough body to hold its own with milk.

Whole beans to grind coarse (1kg)

  • Loba Depths of Maziwa Makuu: a full-bodied, earthy blend from Uganda, Ethiopia and Rwanda, with fruity flavour and hints of dark chocolate.
  • Loba Mystery of Gondwana: Ethiopian Yirgacheffe and Indonesian Sumatra, combining sweet fruit with a full, bold body and a smooth finish.

For decaf drinkers: our Colombian Decaf Espresso Ground comes in 100g sachets and can be used in a plunger. Weigh out what your plunger needs.

For more on matching beans to your brewer, see how to choose coffee beans for espresso, filter and plunger.

Shop the full ranges: ground coffee or coffee beans. Delivery takes 2 to 3 working days, and delivery is free on orders over R450.

Plunger coffee FAQs

Should you stir plunger coffee?

Yes. Stir gently after adding all the water, so every ground is wet and nothing floats in dry clumps. There is no need to stir again before pressing.

Can you use normal ground coffee in a plunger?

You can, but very fine grinds made for espresso machines will taste bitter and leave sludge. Choose a coarse or medium-coarse grind, such as Mugg & Bean ground coffee.

How much coffee for two cups of plunger coffee?

About 31g of coffee (5 to 6 level tablespoons) with 500ml of water.

Can you make filter coffee with a plunger?

A plunger makes immersion coffee, not filter coffee, but the result is similar in strength. For a cleaner, filter-style cup, pour the pressed coffee through a paper filter.

Can you leave coffee in the plunger to keep it warm?

It is better not to. The coffee keeps extracting while it sits on the grounds and turns bitter. Pour it into a flask or carafe instead.

How do you clean a plunger?

Tip the grounds into your compost or bin (not the sink, where they can block drains), rinse the jug and mesh with warm water, and take the mesh apart now and then to wash out trapped grounds.